How To Remove Cylinder From Office Chair Without Pipe Wrench

If your office chair is starting to feel a little wobbly, it might be time to remove the cylinder and give it a good cleaning. Assuming you don’t have a pipe wrench handy, removing a cylinder from an office chair is actually pretty simple. All you need is a few basic tools that you probably already have around the house. This article provides instructions on how to remove a cylinder from an office chair without using a pipe wrench.

Steps for Removing a Cylinder from an Office Chair without a Pipe Wrench

Replacing the cylinder is a relatively easy process that does not require any special tools. Just follow a few simple steps and you’ll have a new cylinder in no time. If you don’t have a pipe wrench, you still need a few tools in your hands. With a screwdriver, a hammer, and pliers, you can easily remove a cylinder from the office chair by following these steps.

First, Remove the screws that hold the base of the chair to the cylinder. There are usually four screws, one on each side. Once the screws are removed, the base should come off easily.

Use the screwdriver to pry off the plastic or metal cap that covers the top of the cylinder. Be careful not to damage the cap, as you’ll need to put it back on later.

Hit the top of the cylinder with the hammer until it pops loose from the bottom part of the chair. You may need to use a bit of force, so be careful not to hit too hard and damage the cylinder.

Once the cylinder is loose, use the pliers to remove it from the chair. You may need to wiggle it a bit to get it out, but it shouldn’t be too difficult.

That’s it! With just a few simple tools, you can easily remove a cylinder from an office chair. Just be sure to put everything back together before you sit down.

 

 

 

 

 

 

Related posts

Leave a Reply

Your email address will not be published.